2.Ground yourself by touching an unpainted metal surface at the back of the computer before touching anything inside your computer.
While you work, periodically touch an unpainted metal surface on the computer to dissipate any static electricity that might harm internal components.
3.Disconnect any devices connected to the computer, including the monitor, from their electrical outlets to reduce the potential for personal injury or shock. Also, disconnect any telephone or telecommunication lines from the computer.
4.Disconnect the power cable from your computer, and then press the power button to ground the system board.
In addition, take note of these safety guidelines when appropriate:
•When you disconnect a cable, pull on its connector, not on the cable itself. As you pull connectors apart, keep them evenly aligned to avoid bending any pins. Also, before you connect a cable, make sure that both connectors are correctly oriented and aligned.
•Handle components and cards with care. Don't touch the components on a card. Hold a card by its edges or by its metal bracket.
CAUTION: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer instructions.
Protecting Against Electrostatic Discharge
To prevent static damage, discharge static electricity from your body before you touch anything inside your computer and periodically while you work inside the computer. You can do so by touching an unpainted metal surface on the back of the computer.
You can also take the following steps to prevent static damage:
•Do not remove items from their antistatic packing material until you are ready to install them in your computer. Just before unwrapping the antistatic packaging, be sure to discharge static electricity from your body.
•When transporting a sensitive component, first place it in an antistatic container or packaging.
Shutting Down the Computer
NOTICE: To prevent data loss, you must turn off your computer through the Start menu rather than by pressing the power button.
HINT: If you are having difficulty turning off your computer, see General Program Problems
Windows XP
1.Save and close any open files and exit any open programs.
2.Click the Start button and then click Turn off Computer.
3.Click Turn off.
The computer automatically turns off after the shutdown process finishes.
4.Turn off your monitor and any other devices connected to power.
Windows Millennium Edition (Me) and Windows 2000
1.Save and exit any programs and files you have open.
2.Click the Start button, and then click Shut Down.
3.Click the
4.Click Shut down and then click OK.
The computer automatically turns off after the shutdown process finishes.
5.Turn off your monitor and any other devices connected to power.
Reattaching the Front Door and Hinge Arms
To prevent damage to your computer, the front door is designed to "break away" if it is lifted up too far. If the front door breaks away, you might need to reattach both the front door and the hinge arms.
Reattaching the Front Door
1.Shut down the computer.
2.Lower the hinge arms to the vertical position.
3.Align the two clips on the inside of the front door with the two hinge arms.
4.Press inward on the front door until it clips to both hinge arms.
