Installing a Media Card Reader
1. Follow the procedures in "Before You Begin."
2. Remove the drive panel.
3. Remove the Media Card Reader and bracket from its packaging.
4. If you are installing a new Media Card Reader rather than replacing one, remove the drive-panel insert from the FlexBay, and then attach the shoulder
screws located in the back of the drive-panel insert to the Media Card Reader.
5. Gently slide the drive (which should not yet be connected to the FlexBay cable) into place until you hear a click or feel the drive securely installed.
6. Connect the USB cable on the back of the Media Card Reader to the front panel USB connector on the system board.
7. Connect the FlexBay USB cable to the back of the Media Card Reader.
8. Route the USB cable through the cable routing clip.
9. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
1
Media Card Reader
2
screws (3)
1
Media Card Reader
2
FlexBay cables