￿￿￿5HSODFH￿WKH￿FRPSXWHU￿FRYHU￿

If the bezel on your drive is not flush with the bezel on your computer, remove the drive and adjust the position of the drive on the bracket, making sure to insert and tighten the screws in the order marked. Replace the drive in the drive bay, and then replace the computer cover.

￿￿￿5HFRQQHFW￿\RXU￿FRPSXWHU￿DQG￿SHULSKHUDOV￿WR￿WKHLU￿SRZHU￿VRXUFHV￿￿DQG￿ WXUQ￿WKHP￿RQ￿

￿￿￿8SGDWH￿\RXU￿V\VWHP￿FRQILJXUDWLRQ￿LQIRUPDWLRQ￿

For a diskette drive, enter the System Setup program and update the appropriate Diskette Drive category (A or B) on Page 1 of the System Setup screens to reflect the size and capacity of your new diskette drive. (For more information, see Chap- ter 2, “Using the System Setup Program.”)

If you installed a non-EIDE tape drive as the second drive, set the Diskette Drive B category to Not Installed.

For EIDE CD-ROM and tape drives, set the appropriate Drive category (0 or 1) under Drives: Secondary to Auto.

￿￿￿9HULI\￿WKDW￿\RXU￿V\VWHP￿ZRUNV￿FRUUHFWO\￿

See your Diagnostics and Troubleshooting Guide for information on running the Dell Diagnostics and troubleshooting any problems that may occur. Use the fol- lowing guidelines to determine which test to use:

If you installed a diskette drive, test it by running all of the subtests in the Diskette Drive(s) Test Group of the Dell Diagnostics.

If you installed a CD-ROM drive, see the documentation that came with the drive for instructions on loading device drivers and using the drive. If it is an EIDE CD-ROM drive, test it by running all of the subtests in the integrated drive electronics (IDE) CD-ROM Drives Test Group of the Dell Diagnostics.

If you installed a tape drive, first verify that your diskette drive is still operat- ing correctly by running all of the subtests in the Diskette Drive(s) Test Group of the Dell Diagnostics. Then perform a tape backup and verification test with the drive as instructed in the software documentation that came with the tape drive.

NOTE: The tape drives sold by Dell come with their own operating software and documentation. After you install a tape drive, refer to the documentation that came with the drive for instructions on installing and using the tape drive software.

,QVWDOOLQJ￿DQ￿(,'(￿+DUG￿'LVN￿'ULYH

This section includes information on installing, partitioning, and formatting EIDE hard- disk drives.

Installing Drives 7-9

Page 119
Image 119
Dell G1 manual Qvwdoolqjdq,+Duglvnulyh, 8SGDWH\RXUV\VWHPFRQILJXUDWLRQLQIRUPDWLRQ, 9HULI\WKDW\RXUV\VWHPZRUNVFRUUHFWO