Dell G1 Ljxuh,Qvhuwlqjwkh+Duglvnulyhlqwkh%Udfnhw, 5HLQVWDOOWKHKDUGGLVNGULYHEUDFNHWLQWKHFKDVVLV

￿

screws (4)

drive bracket

1.6-inch drive tabs (2)

)LJXUH￿￿￿￿￿￿￿￿,QVHUWLQJ￿WKH￿+DUG￿'LVN￿'ULYH￿LQ￿WKH￿%UDFNHW

￿￿$OLJQ￿WKH￿IRXU￿VFUHZ￿KROHV￿RI￿WKH￿GULYH￿DQG￿EUDFNHW￿￿,QVHUW￿DQG￿WLJKWHQ￿ WKH￿VFUHZV￿WKDW￿FDPH￿ZLWK￿\RXU￿XSJUDGH￿NLW￿￿VHH￿)LJXUH￿￿￿￿￿￿￿

If you are replacing a drive in the 1.6-inch slot, use the four screw holes in the side of the bracket. If you are replacing a drive in the 1-inch slot, use the four screw holes in the bottom of the bracket.

￿￿5HLQVWDOO￿WKH￿KDUG￿GLVN￿GULYH￿EUDFNHW￿LQ￿WKH￿FKDVVLV￿

Hold the bracket by its handle, so that it stays at the proper tilt. Let it brush the side of the drive cage as you lower it into the chassis until the two tabs at the bot- tom back of the bracket (see Figure 7-11) fit flush against the front of the rail that extends across the chassis floor and the horizontal lip at the back fits over the rail (see Figure 7-12).

Rotate the bracket down into position, and reinstall the screw you removed in step 4.

￿￿&RQQHFW￿RQH￿RI￿WKH￿GHYLFH￿FRQQHFWRUV￿RQ￿WKH￿(,'(￿FDEOH￿WR￿WKH￿￿￿￿SLQ￿ LQWHUIDFH￿FRQQHFWRU￿RQ￿WKH￿EDFN￿RI￿WKH￿KDUG￿GLVN￿GULYH￿￿VHH￿)LJ￿ XUH￿￿￿￿￿￿￿￿7KH￿FDEOH￿LV￿NH\HG￿VR￿WKDW￿WKH￿FRORUHG￿HGJH￿RI￿WKH￿(,'(￿FDEOH￿ OLQHV￿XS￿ZLWK￿WKH￿SLQ￿￿￿HQG￿RI￿WKH￿LQWHUIDFH￿FRQQHFWRU￿

&$87,21￿￿<RX￿PXVW￿PDWFK￿WKH￿FRORUHG￿VWULS￿RQ￿WKH￿(,'(￿FDEOH￿ZLWK￿SLQ￿￿￿

RQ￿WKH￿,'(￿￿FRQQHFWRU￿WR￿DYRLG￿SRVVLEOH￿GDPDJH￿WR￿\RXU￿V\VWHP￿

7-12 Dell OptiPlex G1 Midsize Managed PC Reference and Installation Guide