Cabling The Dell EqualLogic PS6000/PS6100/PS6500 Storage Arrays
1.Connect a network cable from the network switch 0 to Ethernet 0 on the control module 1.
2.Connect a network cable from the network switch 0 to Ethernet 1 on the control module 1.
3.Connect a network cable from the network switch 1 to Ethernet 2 on the control module 1.
4.Connect a network cable from the network switch 1 to Ethernet 3 on the control module 1.
5.Connect a network cable from the network switch 1 to Ethernet 0 on the control module 0.
6.Connect a network cable from the network switch 1 to Ethernet 1 on the control module 0.
7.Connect a network cable from the network switch 0 to Ethernet 2 on the control module 0.
8.Connect a network cable from the network switch 0 to Ethernet 3 on the control module 0.
9.Repeat steps 1 to 8 to connect the additional Dell EqualLogic PS6000/PS6100/PS6500 storage array(s) to the iSCSI switches.
NOTE: For PS6100 storage array, having all eight cables in steps 1 through 4 provides highest level of cable redundancy. It works fine with only four cables. You can skip either step 1 or 5, either step 2 or 6, either step 3 or 7, and either step 4 or 8.
For more information, see the figures below.
Figure 15. Cabling an iSCSI SAN-Attached Cluster to a Dell EqualLogic PS6000 Storage Array
1. cluster node 1 | 5. Dell EqualLogic PS6000 storage system |
2. cluster node 2 | 6. control module 1 |
3. switch 0 | 7. control module 0 |
4. switch 1 |
|
22
