Problem

Probable Cause

Corrective Action

 

 

 

• The system has just been

• Use the Event Viewer and

booted and services are still

look for the following events

starting.

logged by the Cluster Service:

 

Microsoft Cluster

 

Service

 

successfully formed

 

a cluster on this

 

node.

 

Or

 

Microsoft Cluster

 

Service

 

successfully joined

 

the cluster.

 

• If these events do not appear

 

in Event Viewer, see the

 

Microsoft Cluster Service

 

Administrator’s Guide for

 

instructions on setting up the

 

cluster on your system and

 

starting the Cluster Service.

The cluster network name is not responding on the network because the Internet Connection Firewall is enabled on one or more nodes.

Configure the Internet Connection Firewall to allow communications that are required by MSCS and the clustered applications or services. For more information, see the article KB883398 at support.microsoft.com.

You are prompted to configure one network instead of two during MSCS installation.

Using Microsoft Windows NT 4.0 to remotely administer a Windows Server 2003 cluster generates error messages.

The TCP/IP configuration is incorrect.

The node-to-node network and public

 

network must be assigned static IP

 

addresses on different subnets.

The private (point-to-point) network is

Ensure that all systems are powered

disconnected.

on so that the NICs in the private

 

network are available.

This is a known issue. Some

It is strongly recommended that you

resources in Windows Server 2003

use Windows XP Professional or

are not supported in Windows NT 4.0.

Windows Server 2003 for remote

 

administration of a cluster running

 

Windows Server 2003.

Unable to add a node to the cluster.

The new node cannot access the shared disks. The shared disks are enumerated by the operating system differently on the cluster nodes.

Using Windows Disk Administration ensure that the new cluster node can enumerate the cluster disks. If the disks do not appear in Disk Administration:

1.Check all cable connections.

2.Check the volumes assignments.

3.Select Advanced Minimum.

44

Page 44
Image 44
Dell ISCSI manual Cluster, Select Advanced → Minimum