1 | antenna cables (2) | 2 | Mini-Card |
| | | |
3 | screw | 4 | system-board connector |
| | | |
7. Lift the Mini-Card(s) out of the system-board connector.
CAUTION: When the Mini-Card is not in the computer, store it in protective antistatic packaging. For more information, see "Protecting Against Electrostatic Discharge" in the safety information that shipped with your computer.
Replacing the Mini-Card(s)
1.Follow the instructions in Before You Begin.
2.Remove the new Mini-Card from its packaging.
CAUTION: Use firm and even pressure to slide the card into place. If you use excessive force, you may damage the connector.
CAUTION: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system board, and realign the card.
CAUTION: To avoid damage to the Mini-Card, never place cables under the card.
3.Insert the Mini-Card connector at a 45-degree angle into the system-board connector.
4.Press the other end of the Mini-Card down into the slot on the system board and replace the screw that secures the Mini-Card to the system board.
5.Connect the appropriate antenna cables to the Mini-Card you are installing. The following table provides the antenna cable color scheme for the Mini- Cards supported by your computer.
