Removing the Display Assembly
Replacing the Display Assembly
Removing the Display Bezel
Replacing the Display Bezel
Removing the Display Panel
Replacing the Display Panel
Display Inverter
Removing the Camera and Microphone Assembly
Replacing the Camera and Microphone Assembly
Removing the Latch Hook
Replacing the Latch Hook
Removing the Display Bracket
Replacing the Display Bracket
Remove the Display Cover
Replace the Display Cover
Removing the Display Assembly
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTICE: Position all display assembly cables toward the back, away from the base assembly before installing the display assembly.
1.Follow the instructions in Before Working on Your Computer.
2.Close the display and turn the computer over.
3.Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly).
4.Remove the hinge covers (see Removing the Hinge Covers).
5.Disconnect the display cable and the wireless antenna cables.
6.Remove the display cable and the wireless antenna cables (WLAN, WWAN, and WPAN) from their routing channels. Position all cables to the rear and away from the laptop.
1 display cable | 2 WPAN antenna cable |
3WLAN antenna cable 4 WWAN antenna cable
7.Remove the two M2.5 x
1 
M2.5 x 
