Dell PP30L manual Removing the Hinge Covers, Replacing the Hinge Covers

Back to Contents Page

Hinge Covers

Dell Precision™ Service Manual

Removing the Hinge Covers

Replacing the Hinge Covers

Removing the Hinge Covers

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

The hinge covers are not interchangeable; the left one covers the multimode DisplayPort and the right one covers the RJ-45 network connector.

1.Follow the procedures in Before Working on Your Computer.

2.Close the display and turn the computer over.

3.Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly).

4.Remove the two M2.5 x 5-mm screws from each hinge cover.

5.Slide each hinge cover off the computer and lift to remove it.

1	display port	2	M2.5 x 5-mm screw (4)
3	RJ-11 network connector	4	hinge cover (2)

Replacing the Hinge Covers

1.Slide the left hinge cover over the display port and slide the right hinge cover over the RJ-45 network connector.

2.Replace the M2.5x5-mm screws in each hinge cover.

3.Replace the bottom of the base assembly (see Replacing the Bottom of the Base Assembly).

4.Follow the procedure After Working on Your Computer.

Back to Contents Page