Dell R200 - page 28

28 About Your System
Time-of-day not set
- please run SETUP
program
Incorrect Time or Date
settings; faulty system
battery.
Check the Time and Date
settings. See "Using the
System Setup Program" on
page35. If the problem
persists, see
"Troubleshooting the
System Battery" on
page106.
Timer chip counter
2 failed Faulty system board. See "Getting Help" on page127.
Unexpected
interrupt in
protected mode
Faulty or improperly
installed memory modules
or faulty system board.
Ensure that all memory
modules are properly
installed. See "Memory
Module Installation
Guidelines" on page81. If
the problem persists, see
"Troubleshooting System
Memory" on page108. If
the problem persists, see
"Getting Help" on
page127.
Utility partition
not available Utility partition is not available on the hard disk
Create a utility partition on
the boot hard drive. See the
CDs that came with your
system.
Warning! No micro
code update loaded
for processor 0
Micro code update failed. Update the BIOS firmware.
See "Getting Help" on
page127.
Table 1-4. System Messages (continued)
Message Causes Corrective Actions
book.book Page 28 Thursday, August 30, 2007 3:30 PM