Back to Contents Page
I/O Panel
Dell™ OptiPlex™ XE Service
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the I/O Panel
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.
1.Follow the procedures in Before Working Inside Your Computer.
2.Remove the front panel.
3.Remove the optical drive.
4.Remove the hard drive.
5.Remove the back thermal sensor.
6.Disconnect the I/O panel cable from its connector on the system board.
7.Remove the screws that secure the I/O panel to the chassis.
8.Remove the I/O panel from the computer.
Replacing the I/O Panel
To replace the I/O panel, perform the above steps in reverse order.
