DeLonghi ETAM36.365 manual Displayed Messages, Water delivery

DISPLAYED MESSAGES

DISPLAYED MESSAGE	POSSIBLE CAUSE	SOLUTION
FILL TANK	Insufficient water in the tank.	Fill the tank with water and/or insert it correctly, pushing it
		as far as it will go until it clicks into place.
EMPTY GROUNDS CONTAINER	The grounds container (A18) is full.	Empty the grounds container and drip tray, clean and replace
		(fig. 29).
		Important: when removing the drip tray, the grounds contai-
		ner MUST be emptied, even if it contains few grounds.
		If this is not done, when you make the next coffees, the
		grounds container may fill up more than expected and clog
		the machine.
GROUND TOO FINE	The grinding is too fine and the coffee is delivered too slowly	Repeat coffee delivery and turn the grinding adjustment
ADJUST MILL	or not at all.	dial (fig. 13) one click clockwise towards “7” while the coffee
		mill is in operation.
		If after making at least 2 coffees delivery is still too slow,
		repeat the correction procedure, turning the grinding
		adjustment dial another click until delivery is correct (see
		the section “Adjusting the coffee mill” on page 13).
INSERT GROUNDS CONTAINER	After cleaning, the grounds container has not been repla-	Remove the drip tray and insert the grounds container.
	ced.
ADD PRE-GROUND COFFEE	The “pre-ground coffee” function has been selected without	Place pre-ground coffee in the funnel or deselect the “pre-
	placing any pre-ground coffee in the funnel.	ground” function (fig. 18).
DESCALE	The machine must be descaled.	The descaling procedure described in the section “Descaling”
		needs to be performed as soon as possible (page 18).
REDUCE COFFEE AMOUNT	Too much coffee has been used.	Select a milder taste by pressing the aroma selection
		button (fig. 10) or reduce the quantity of pre-ground coffee.
FILL BEANS CONTAINER	The coffee beans have run out.	Fill the beans container (fig. 14).
	The pre-ground coffee funnel is clogged.	Empty the funnel with the help of a brush as described in the
		section “Cleaning the pre-ground coffee funnel”.
INSERT INFUSER ASSEMBLY	The infuser has not been replaced after cleaning.	Insert the infuser as described in the section “Cleaning the
		infuser”.
INSERT TANK	The tank is not correctly in place.	Insert the tank correctly and press as far as it will go.
GENERAL ALARM	The inside of the appliance is very dirty.	Clean the inside of the appliance thoroughly, as described in
		the section “Cleaning”. If the message is still displayed after
		cleaning, contact customer services.
WATER CIRCUIT EMPTY FILL	The water circuit is empty	Press OK to deliver water from the spout (A11) until it flows
WATER CIRCUIT		out normally.
Water delivery
PRESS OK
REPLACE FILTER	The water softener filter is exhausted.	Replace the filter or remove it as described in the section
		“Water softener filter”.
TURN DIAL TO CLEAN	Milk has been delivered recently and the tubes inside the	Turn the froth adjustment dial to CLEAN.
	milk container must be cleaned.
INSERT WATER SPOUT	The water spout is not inserted or is inserted incorrectly.	Insert the water spout (D5) as far as it will go.
INSERT MILK CONTAINER	The milk container is not inserted correctly.	Insert the milk container (fig. 23) as far as it will go.
DESCALE	Descaling is necessary.	See par. “DESCALING”.
REPLACE FILTER	Replace water filter.	See par. “Replace water filter”.

20