13
ADJUSTING THE ROLLER EXTENSION TABLES
The roller tables must be set according to these instructions
to avoid snipe. Follow instructions below for both infeed
and outfeed tables.
1. Loosenthreebolts(HH) Fig.25.Loosen justenough
so table can be moved up or down to make the
adjustments described below.
2. Placeashortstraightedge(II)Fig.26atononeside
oftheplaten(JJ)andtouchingtheinsideroller(KK).
3. Adjust the table so that the straight edge will rest
evenlyon theplaten(JJ) Fig.26 andthe topof the
insideroller(KK).Tightenthebolt(HH)thatisdirectly
below the straight edge.
4. Movestraightedge(II)totheothersideofplatenand
adjust table so the straight edge will rest evenly on
the platen and the top of this side of the inside roller.
Tightenthebolt(HH)thatisdirectlybelowthestraight
edge on that side of the table. Then tighten the middle
bolt. Now all three bolts should be tight and the inside
roller should be level with the platen.
5. Placetwodimes(LL)Fig. 27inlinewitheach other,
one at each end of one side of the platen as shown.
6. Placealongstraightedge(oneshowninFig.28is48"
(122cm))onbothdimes(LL)andextenditoutuntilit
alsotouchestheouterroller(MM)Fig.28.
7. Loosenscrews(NN) (oneshown atFig.29) onboth
sides of roller table. loosen just enough so the end of
the roller table can lifted up or pushed down to make
the adjustment described below.
8. Adjusttable(byliftingorloweringtheouterroller)so
that the straight edge will rest evenly on the dimes
(oneisshownat(LL)Fig.28)andthetopoftheouter
roller(MM)Fig.27. Tightenthescrew(NN)that ison
the same side of table as straight edge.
9. Move straight edge and dimes to the other side of the
platen and roller table and repeat STEP 8.
10. Re-check the inside roller for proper alignment as
described in STEP 3. Repeat STEP 3 if needed.
11. Re-check the outer roller for proper alignment as
described in STEP 8. Repeat STEP 8 if needed.
12. Repeat process for other table.
HH
NN
LL
LL
KK
II JJ
MM
Fig. 26
Fig. 27
Fig. 28
Fig. 25
Fig. 29