19
3. Movethegaugeblock (A)Fig.52without thefeeler
gaugeunder one end of the infeed roller (C). The
bottomoftheinfeed roller(C)should touchthetop
ofthegaugeblock(A).
4. Toadjust, loosen the nut (D) Fig. 52 and turn the
adjustingscrew(E)untilthatend oftheinfeedroller
touches the top of the gauge block. Tighten the nut
(D).
5. Repeat this adjustment with the gauge block on the
opposite end of the infeed roller.
1. Make sure the knives are adjusted properly as ex plained under How To Check, Adjust, And Re place Knives.
2. Placethegaugeblock(A)Fig.53onthetabledirectlyunderneath thecutterhead.Placea0.040"(1.01mm)feeler
gauge(B)ontopofthe gaugeblock.Raiseorlowerthehead assemblyuntiloneoftheknives touchesthefeeler
gauge. Tighten the head locking knobs.
3. Movethegaugeblock(A)Fig.54withoutthefeelergaugeundertheendoftheoutfeedroller(C).Thebottomofthe
out-feedroller(C)shouldtouchthetopofthegauge block(A).
4. Toadjust,loosenthenut(D)Fig.54andturnthescrew(E) untiltheoutfeedrollerisproperlyadjusted.
5. Repeat this adjustment procedure on the opposite end of the outfeed roller.
HOW TO ADJUST THE TENSION OF THE INFEED AND OUTFEED ROLLERSThe infeed and outfeed are under spring tension. The
tension should be sufficient to feed the stock uniformly
without slip ping, but should not be so tight that it causes
damage to the board. The tension should be equal at
both ends of each roller.
To adjust the spring tension of the infeed roller, turn two
screws,oneofwhichis shownat(A)Fig.55. Theother
screw is located on the opposite side of the machine.
Adjust the two screws (A) until FOUR threads show
above the table casting. Further tension adjustment may
be necessary.
To adjust the spring tension of the outfeed roller, turn two
screws,oneofwhichis shownat(B)Fig.55. Theother
screw is located on the opposite side of the machine.
Adjustthetwoscrews(B)untilONE thread shows above
the table casting. Further tension adjustment may be
necessary.
A
E
D
C
HOW TO ADJUST THE HEIGHT OF THE OUTFEED ROLLERA
B
Fig. 52
Disconnect the machine from the power source.
The outfeed roller was adjusted at the factory to be 0.040" (1.01 mm) below the cutting circle. To check and adjust
the height of the outfeed roller:
A
C
E
D
Fig. 53 Fig. 54
A
B
Fig. 55