22
LUBRICATION OF GEARS
Changeyourgearboxoilonceayear.Useextremepressuregearoil, availablefromDELTAinonepint(473ml)cans.
Youwillneedapproximately20oz.(591ml).Thegearboxdrain plugisshownat(A)Fig.62.The oilfillandlevelplug
isshownat(B)Fig.63.
Lubricatethefourelevationscrews,twoofwhichareshownat (C)Fig.64,asneededusingacommongrease.
Periodicallyremovethescrew (D)andtheside cover(E).Thoroughly cleanthechainsand sprockets(F)Fig.65 and
lubricate,usingalightmachineoil.Replacetheside cover(E)Fig.64.Securewiththescrew(D).
Fig. 62 Fig. 63
Fig. 64 Fig. 65
A
B
D
C
EFF
F
LUBRICATION OF INFEED/OUTFEED ROLLERS
The infeed and outfeed rollers can be lubricated through
fourholes(twoofwhich areshownat(G)Fig. 66)inthe
top of the planer head.
NOTE: The other two holes are located on the other side
of the planer head, just above the ends of the infeed and
outfeed rollers.
Add2-3dropsof10Wmachineoilintoeachhole(G)Fig.
66 every 50 hours of use. G
Fig. 66