ERROR MESSAGES (CONT.)
CMOS Time and Date Not Set
Diskette Boot Failure
Display Switch Not Proper
DMA Error
DMA #1 Error
DMA #2 Error
FDD Controller Failure
HDD Controller Failure
INTR #1 Error
INTR #2 Error
Invalid Boot Diskette
Keyboard Is Locked...Unlock It
Keyboard Error
KB/Interface Error
Off Board Parity Error
On Board Parity Error
Parity Error ????
Run Standard CMOS Setup to set the date and time in CMOS RAM.
The boot disk in floppy drive A: is corrupt. It cannot be used to boot the system. Use another boot disk and follow the screen instructions.
The display jumper is not implemented on this product, this error will not occur. Error in the DMA controller.
Error in the first DMA channel. Error in the second DMA channel.
The BIOS cannot communicate with the floppy disk drive controller. Check all appropriate connections after the system is powered down.
The BIOS cannot communicate with the hard disk drive controller. Check all appropriate connections after the system is powered down.
Interrupt channel 1 failed POST. Interrupt channel 2 failed POST.
The BIOS can read the disk in floppy drive A:, but cannot boot the system. Use another boot disk. The keyboard lock on the system is engaged. The system must be unlocked to continue.
There is a timing problem with the keyboard. Set the Keyboard option in Standard CMOS Setup to Not Installed to skip the keyboard POST routines.
There is an error in the keyboard connector.
Parity error in memory installed in an expansion slot. The format is:
OFF BOARD PARITY ERROR ADDR (HEX) = (XXXX)
XXXX is the hex address where the error occurred.
Parity is not supported on this product, this error will not occur.
Parity error in system memory at an unknown address.
ISA NMI MESSAGES
ISA NMI Message
Memory Parity Error at xxxxx
I/O Card Parity Error at xxxxx
DMA Bus
Explanation
Memory failed. If the memory location can be determined, it is displayed as xxxxx. If not, the message is Memory Parity Error ????.
An expansion card failed. If the address can be determined, it is displayed as xxxxx. If not, the message is I/O Card Parity Error ????.
A device has driven the bus signal for more than 7.8 microseconds.
Advanced/RH Technical Product Specification ∙ Page 45
