Delta 33-891, 33-892, 33-890, 33-895X Adjusting the Table Brackets Parallel to the Track ARM

ATTACHING THE STARTER BOX TO THE BASE (33-891 AND 33-892 MODELS)

For machines with a magnetic starter, transformer, and overload protection, follow these instructions to attach the starter box to the base:

1.Attach the bracket (A) to the bottom of the right side of the saw base (Fig. 13). Place a 1/4" flat washer on a 1/4-20 x 3/4" hex head screw. Insert the screw through the hole in the bottom of the right side of the saw base. Place the bracket (A) Fig. 13 on the screw. Place a 1/4" lock washer on the screw. Thread a 1/4- 20 hex nut on screw. Tighten securely.

2.Attach the starter box (B) Fig. 14 to the right side of the base. Place a 1/4" lockwasher on a 1/4-20 x 1/2" hex head screw. Place a 1/4" flat washer on the screw. Insert the hex head screw (C) through the hole in the in the bracket (E). Thread the screw into the weld nut (D) Fig. 14 in the back of the starter box (B). Repeat this process for the two remaining holes in the base (G) and the holes (F) in the starter box.

A

Fig. 13

	G	F
C
	E	B
		D

Fig. 14

ADJUSTING THE TABLE BRACKETS PARALLEL TO THE TRACK ARM

To perform accurate work, be sure that the track arm is parallel to the table top brackets at both the front and rear of the machine. To check the alignment:

1.Loosen the yoke clamp locking lever (A) Fig. 15. Pull up the yoke clamp index knob (B) and rotate the yoke (C) Fig. 16 to the out-rip position. Tighten the yoke clamp locking lever (A) Fig. 15.

A

C

B

Fig. 15

B
A	C

Fig. 16

2.Use the open-end wrench (D) Fig. 17 on the flats of the arbor and loosen the arbor nut (E) with the other wrench (F).

D

E

F

Fig. 17

11