7.To adjust, remove the screw (R) Fig. 22. Loosen the locknut (S) and turn the leveling screw (T) to raise or lower table mounting bracket (N). After adjustment, tighten the locknut (S) and replace the screw (R).
8.Check and adjust the other table mounting bracket in the same manner.
IMPORTANT: Do not raise or lower the track arm assembly during this operation.
R
N
T
S
Fig. 22
9.Place a straight edge (V) Fig. 23 on the table mounting brackets (N). Adjust the two center positions (W) on both brackets.
W
N 
V
Fig. 23
ATTACHING THE TABLE CLAMPS AND TABLE CLAMP RODS
1.Unscrew the metal clamps from the table clamp rods.
2.Position the metal clamp (A) Fig. 24 on the end of the table mounting bracket (B).
NOTE: Attach the metal clamp (A) so that the threaded hole (C) is on the inside of table mounting bracket.
3.Insert the threaded end of table clamp rod (D) Fig. 25 through the metal support (E) at the front of the saw. Thread the rod through the tapped hole in the table clamp (A).
4.Attach the remaining table clamp and
B
A
C
Fig. 24
A
D
E
Fig. 25
13
