5.Insert the metal shaft (J) Fig. 12 through the hole in the side of the sleeve (G) and into the wide slots of the pivot cover (H) Fig. 12. Thread the T-handle screw (K) Fig. 13 into the hole of the shaft (J), just enough to hold the pivot pin assembly in position.

6.Fig. 14 illustrates the pivot ball and overarm attached to the stock feeder.

7.Loosely thread three M10 x 50MM hex head screws (L) Fig. 15 into the holes in the overarm clamp assembly (M).

8.Insert an M8 hex nut (P) Fig. 16 into the hex recess of the overarm clamp assembly (M). Loosely thread the lever

(R) with a flat washer into the clamp assembly (Fig. 17).

G

J

Fig. 12

H

J

K

Fig. 13

M

L

Fig. 14

Fig. 15

M

R

P

Fig. 16

Fig. 17

11

Page 11
Image 11
Delta 36-865 instruction manual