
6.Insert the straight end of the overarm (A) Fig. 29 through the housing (E). Attach the pivot ball (F) Fig. 29 to the over- arm (A) with a
NOTE: Make certain that the screw and lockwasher (K) are recessed inside pivot ball (F).
7.Push the pivot ball, attached to the overarm (A) Fig. 31, to the front of the housing (E). Place the cover (M) over the pivot ball (F) with the wider slots of the cover (M) positioned horizontally. Insert the metal shaft (N) Fig. 32 through the hole in the side of the sleeve (P) and the wide slot of the cover (M). Fasten in place with the
8.
A
E
F
F
K
Fig. 29
A
E
M |
| F |
Fig. 31
R
K
Fig. 30
A | E |
|
P
N
M
R
Fig. 32
S
C
D
Fig. 33
Fig. 34
14