Delta 36-865 instruction manual Operation, Motor Control Switch

MOUNTING THE VERSA-FEEDERTMTO A MACHINE TABLE

Decide on the location you wish to mount the Versa-FeederTMon your machine. Refer to Figs. 44, 45, and 46 for assistance when mounting the stock feeder assembly to a table saw, jointer, or shaper. To mount the stock feeder assembly to a machine table:

1.Position the mounting bracket (A) Fig. 35 at your desired location.

2.Mark the location where four mounting holes are to be drilled.

3.Center punch and drill four 3/8" diameter holes at the locations marked in STEP 2.

NOTE: Do not drill through any table ribs or table supports.

4.Fasten the mounting bracket (A) Fig. 36 to the table with four M10 x 30MM hex head screws and lockwashers and hex nuts, three of which are shown at (B).

A

B

A

Fig. 35

Fig. 36

OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

MOTOR CONTROL SWITCH

To operate the stock feeder, pull out on the knob (A) Fig. 40. To stop the stock feeder, push in on the knob (A).

A

Fig. 37

15