Alcatel-Lucent 6600 Series, 6648 Attaching a Rack-Mount Flange, Attaching the Switch to the Rack

OmniSwitch 6600 Series Chassis and Hardware Components Mounting the Switch

To rack-mount the switch, follow the steps below:

1Align the holes in the provided rack-mount flanges with the four threaded holes in the OmniSwitch chassis. These threaded holes are located in the left and right sides of the chassis, near the front panel.

2Attach the flanges to the chassis using the provided Phillips-head screws. Be sure to tighten each of the screws firmly using a Phillips screwdriver.

4 662

OmniSwitch

TM

CONSOLE

			P
			M
		I	TE
	1	PR
1	PS		N
K			FA
O		C
	2	SE
K2	PS
O

SEL

Attaching a Rack-Mount Flange

3After the rack-mount flanges are secured to the chassis, mark the holes on the rack where the switch is to be installed.

4Lift and position the switch until the rack-mount flanges are flush with the rack post.

5Align the holes in the flanges with the rack holes that were marked in step 3.

6Once the holes are aligned, insert a rack mount screw (not provided) through the bottom hole of each flange. Tighten both screws until they are secure.

7

8 3

4

49

			G
		ACKIN
	N	/ST	5
N	SIO
EXPA
5

50

	N
AN	SIO
EXP

Attaching the Switch to the Rack

Note. Be sure to install the screws in the bottom hole of each flange, as shown, before proceeding.

OmniSwitch 6600 Series Hardware Users Guide April 2004 page 2-15