Alcatel-Lucent 6624, 6648, 6600 Series manual Monitoring Stacks, Monitoring Stack Topology

Monitoring Stacks Managing OmniSwitch 6600 Series Stacks

Monitoring Stacks

As shown in the figure below, OmniSwitch 6600 series stacks can be managed and monitored with Command Line Interface (CLI) commands, WebView, SNMP, and OmniVista. See “Monitoring Stack Topology” on page 3-19for information on monitoring stack configurations and see Chapter 2, “OmniSwitch 6600 Series Chassis and Hardware Components,” for information on monitoring and moni- toring stack temperature and chassis configurations.

OmniSwitch 6624 Stack

Stacks can be managed and monitored through the console port with CLI commands.

Stacks can be managed and monitored through Ethernet ports with CLI commands, WebView, SNMP, and OmniVista.

Managing and Monitoring OmniSwitch 6600 Series Stacks

Note. See the OmniSwitch CLI Reference Guide for complete descriptions of CLI commands.

Monitoring Stack Topology

To monitor the topology of individual switches within a stack or all switches within a stack use the show stack topology command by entering

-> show stack topology

at the CLI prompt. A screen similar to the following will be displayed:

NI	Role	Link A	Link A	Link A	Link B	Link B	Link B
		State	RemoteNI	RemoteLink	State	RemoteNI	RemoteLink
---+-----------		+---------	+---------	+-----------	+---------	+---------	+----------
1	PRIMARY	ACTIVE	2	27	ACTIVE	2	28
2	SECONDARY	ACTIVE	1	51	ACTIVE	1	52

The Role field displays the Chassis Management Module (CMM) role of the switch. The “RemoteNI and “RemoteLink” fields display how the stacking ports are connected to each other within this stack. “Link A” refers to the left-hand stacking port (Port 27 on OS6624 and OS6600-U24 switches and Port 51 on OS6648 switches) and “Link B” refers to the right-hand stacking port (Port 28 on OS6624 and OS6600- U24 switches and Port 52 on OS6648 switches).

page 3-20 OmniSwitch 6600 Series Hardware Users Guide April 2004