MACHINE USE
DISCONNECT MACHINE
FROM THE POWER SOURCE.
1.You can rotate the entire feeder assembly (A) Fig. 38 360 degrees in the mounting bracket by loosening the locking lever (B).
2.To raise or lower the feeder assembly (A) Fig. 38 , loosen the lever (C) and move the overarm (D).
3.To move the feeder assembly (A) Fig. 38 in or out, loosen the locking lever (E) and rotate the
4.To adjust the position of the stock feeder (A) Fig. 38, loosen the
5.Tighten all the locking levers after all adjustments are made.
IMPORTANT: If you are using a dust collection system with the stock feeder, refer to the section “DUST CHUTE”.
ADJUSTING FEED RATES
Variable speeds from 10 FPM to 46 FPM are available with the stock feeder. To change the feed rates, rotate the knob (A) Fig. 39 until the desired feed rate is indicat- ed by the pointer (B) on the knob.
NOTE: Each dot on the feed rate scale (C) will increase or decrease the feed rate approximately 4 FPM.
CHANGING THE DIRECTION OF FEED
The machine features a
DUST CHUTE
The stock feeder features a
IMPORTANT: If you are using a dust collection system with the stock feeder, use the following instructions. If you are not using a dust collection system, disregard these instructions.
DISCONNECT MACHINE
FROM THE POWER SOURCE.
1.Loosen the three screws, one of which is shown at
(B)Fig. 40, and remove the cover (C).
2.Use a flat-head screwdriver or similar tool to carefully knock out the four individual plastic seg- ments located at the bottom of dust chute (A) Fig. 40.
IMPORTANT: DO NOT remove the cross-section (D) Fig. 41. Replace the cover (C) Fig. 40.
A | D | B | E |
G
F
C
Fig. 38
C | B |
A 
D
Fig. 39
C |
| A |
B
Fig. 40
A
D
C
Fig. 41
16
