Delta 50-852, 50-853 instruction manual

4.Apply a bead of silicone sealant around flange of chute (F) Fig. 9. Align holes in ten-hole gasket (G) Fig. 9, with mounting holes in blower flange (F) and press gasket onto flange as shown.

5.Align mounting holes in dust chute (H) Fig. 10, with gasket (G), assembled in STEP 4. Place a lockwasher onto a hex head screw, insert screw through the chute and gasket, thread the screw into the motor assembly, and tighten securely. Repeat this process for the 9 remaining holes. Fig. 11 shows the dust chute assembled to the motor assembly.

6.Align the two holes in “U” bracket (L) Fig. 12, with two pre-drilled holes (M) in left hand drum. Place a lockwasher (R), then a flat washer (S) onto the hex head screw (P). Insert the hex head screw through the hole in the “U” bracket and the hole in the drum, thread the hex nut (T) onto the hex head screw and tighten securely as shown in Fig. 13. Repeat this process for the remaining hole. Assemble the remaining “U” bracket to right hand drum in the same manner.

F

G

Fig. 9

H

G

Fig. 10

Fig. 11

M

T

L

S R P

Fig. 12

6