ASSEMBLING DUST INTAKE PORT TO BLOWER AND MOTOR ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR IS DISCONNECTED FROM THE POWER SOURCE.
1.Align the four holes in the dust intake port (A) Fig. 29, with the mounting holes in the lip of flange (B) of blower assembly and fasten with four sheet metal screws (C).
2.Fig. 30, illustrates the dust intake ports assembled to the blower assembly.
3.Four dust intake port caps (D) Fig. 31, are supplied with the dust collector. These caps should be installed to cover any unused intake ports or when the dust collector is not in use.
WARNING: DO NOT INSERT FINGERS INTO THE INTAKE PORTS WHEN UNIT IS OPERATING.
B
A
C
Fig. 29
Fig. 30
D
Fig. 31
CONNECTING MACHINE TO POWER SOURCE
ELECTRICAL CONNECTIONS
The motor rating of your dust collector is either 230/460 Volt, Three Phase; or 230 Volt, Single Phase. Before connecting the motor to the power line, make sure the switch is in the “OFF” position and be sure that the electric current is of the same characteristics as indicated on the tool. All line connections should make good contact. Running on low voltage will damage the motor. 
WARNING: THIS TOOL MUST BE GROUNDED WHILE IN USE
TO PROTECT THE OPERATOR FROM ELECTRIC SHOCK.
11
