Delta DLKC6580V2-1 instruction manual Minal box area

PROBLEM	CAUSE	CORRECTION
Motor will not	Motor overload protection	Let motor cool off and over-
run.	switch has tripped	load switch will automatically
		reset.
	Tank pressure exceeds	Motor will start automatically
	pressure switch “cut-in”	when tank pressure drops
	pressure.	below “cut-in” pressure of
		pressure switch.
	Check valve stuck open.	Remove and clean, or replace.
	Loose electrical connec-	Check wiring connection
	tions.	inside pressure switch and ter-
		minal box area.
	Possible defective motor	Have checked by a Trained
	or starting capacitor.	Service Technician.
	Paint spray on internal	Have checked by a Trained
	motor parts.	Service Technician. Do not
		operate the compressor in the
		paint spray area. See flamma-
		ble vapor warning.
	Pressure release valve on	Bleed the line by pushing the
	pressure switch has not	lever on the pressure switch to
	unloaded head pressure.	the “off” position; if the valve
		does not open, replace switch.
	Fuse blown, circuit breaker	1. Check fuse box for blown
	tripped.	fuse and replace as nec-
		essary. Reset circuit
		breaker. Do not use a fuse
		or circuit breaker with
		higher rating than that
		specified for your particu-
		lar branch circuit.
		2. Check for proper fuse. You
		should use a time delay
		fuse.
		3. Check for low voltage
		conditions and/or proper
		extension cord.
		4. Disconnect the other elec-
		trical appliances from cir-
		cuit or operate the com-
		pressor on its own branch
		circuit.

D26161 24-ENG