Delta Electronics 14-651 instruction manual Assembly Tools Required, Assembly Time Estimate

ASSEMBLY

For your own safety, do not connect the machine to the power source until the machine is completely assembled and you read and understand the entire instruction manual.

ASSEMBLY TOOLS REQUIRED

Chuck Key/Wrench (Supplied)

ASSEMBLY TIME ESTIMATE

Assembly for this machine takes less than 30 minutes.

HOW TO RAISE AND LOWER THE HANDLE

1.Attach the hub of the handle assembly (A) Fig. 1 to the end of the pinion shaft (B). Fasten the handle to the pinion shaft using the special screw (C) and spring (D).

2.Raise the mortising machine head (E) Fig. 2 to the “up” position by turning the handle (A) clockwise.

NOTE: The handle (A) is spring-loaded. Reposition it by pulling it out and moving it on pinion shaft (B).

B

Fig. 1

A

C

D

A

E

B

Fig. 2

ATTACHING THE HYDRAULIC CYLINDER

Place the head (A) Fig. 3 in the “up” position. Attach the hydraulic cylinder (B) to the two fittings, one located on the back of the head (C) Fig. 3, and the other on the column (D) Fig. 4. Push each end of the hydraulic cylinder on its fitting to secure the cylinder.

A

B

C

Fig. 3

D

B

Fig. 4

7