Delta Electronics VFD007S23A manual For Vfdxxxsxxe PNP source mode

Chapter 2 Installation and WiringVFD-S Series

For VFDXXXSXXE

PNP (source mode)

					Braking resistor (optional)
				Jumper		select 80	Ω 120W, 200Ω 120W
Main Circuit Power						400Ω 120W
				E +1 +2/B1		B2
NFB							AC Motor
R/L1				R/L1		U/T1
							IM
S/L2				S/L2		V/T2
T/L3				T/L3	+17V		3~
		SA				W/T3
Recommended Circuit				RB			Grounding resistance
			MC		CPU	E
when power supply				RC			less than 100Ω
is turned OFF by a	OFF	ON	MC
fault output					2.4Ω	47Ω AFM	Potentiometer(1KΩ )

Common signal (source)				47KΩ	+	Analog output
Forward/Stop	17V 20mA		11V		-	DC 0～10V
	M0
Reverse/Stop				GND	Factory default: indicate
	M1
Reset					output frequency
	M2		NPN	RA	Multi-function indication
Multi-step 1
	M3		PNP		output contacts below
Multi-step 2	M4	J2		RB	120VAC/24VDC 5A
Multi-step 3				RC	Factory default:
	M5
					indicates malfunction

		GND			Mo1	Multi-function Photocoupler
		E
Analog voltage	3	+10V 10mA				output below 48VDC 50mA
						Factory default: Indicates
0～10VDC		(MAX)
Potentiometer	Pot. 2	2	1		MCM	during operation
3K～5KΩ		AVI	3	47KΩ	RJ-11	RJ-11 communication port with
Analog current	1
		250Ω				RS-485 serial interface
		GND			6← 1	1:17V
Factory default: output freq. (Pot.)						2:GND
						3:SG-
determined by the Potentiometer
						4:SG+
on the control panel.
Main circuit (power) terminals		Control circuit terminals				Shielded leads

NOTE: Do not plug in a Modem or telephone line to the RS-485 communication port, permanent damage may result. Terminal 1 & 2 are the power sources for the optional copy keypad and should not be used while using RS-485 communication.

*If it is single phase model, please select any of the two input power terminals in main circuit power.

2-20 Revision August 2006, SE08, SW V2.61