Chapter 2 Installation and
Terminal | Terminal Function |
| Factory Settings (NPN mode) | |
Symbol |
| ON: Connect to GND | ||
|
| |||
|
| |||
|
| operation frequency | ||
|
| PID feedback signal | ||
|
| AVI input impedance: 100kohm | ||
|
| ACI input impedance: 250kohm | ||
|
| AVI | +10V | AVI circuit |
|
| ACI | ||
|
|
|
| |
|
| J1 |
|
|
| Analog voltage Input |
| AVI |
|
| (AVI/ACI) |
|
| |
AVI |
|
|
| |
|
|
|
| |
|
|
| GND | Internal Circuit |
|
|
|
| |
|
| AVI |
| ACI circuit |
|
| ACI | ACI | |
|
|
| ||
|
| J1 |
| |
|
|
|
| |
GND
Internal Circuit
Control signal wiring size: 18 AWG (0.75 mm2) with shielded wire.
Analog input terminals (AVI, GND)
Analog input signals are easily affected by external noise. Use shielded wiring and keep it as short as possible (<20m) with proper grounding. If the noise is inductive, connecting the shield to terminal GND can bring improvement.
If the analog input signals are affected by noise from the AC motor drive, please connect a capacitor (0.1 μ F and above) and ferrite core as indicated in the following diagrams:
AVI
C
GND
ferrite core
wind each wires 3 times or more around the core Digital inputs (M0~M5, GND)
When using contacts or switches to control the digital inputs, please use high quality components to avoid contact bounce.
Revision August 2006, SE08, SW V2.61 |
