System Setup

Use System Setup to customize a variety of settings to suit your listening environment.

For the contents of a system menu and the initial setting of this unit ( page 17).

ENGLISH

System Setup

Setting the Speaker Configuration

The composition of the signals output to each channel and the frequency response are adjusted automatically according to the combination of speakers actually being used.

Front display

•You can change the settings using the buttons on the remote control unit.

•The AVR-1506 is equipped with an alpha numeric front panel display that can also be used to check and adjust settings. Some representative front display examples are shown below.

1 Press the CURSOR F or G button to select your front speaker type, then press the ENTER or CURSOR Hbutton to switch to the center speaker setting.

MODE 1

ENTER

SETUP

CURSOR

No.

[ Display ]

*COAX1 CD

Currently selected line

 

Current setting

Press the CURSOR F button to execute.

*TEST TONE Yes<

Currently selected line

1 Set the MODE 1 switch to “AUDIO”.

2 Press the SETUP button to enter the setting.

*System Setup

3 Press the ENTER or CURSOR H button to select the setting, then press the CURSOR F or G button to select the parameter.

*Front Large

LargeSmall

4 Press the ENTER or CURSOR Hbutton to confirm the new settings.

*Center Small

LargeSmallNone

5 Press the SETUP button to finish system set up.

*Front Large

LargeSmall

2 Press the CURSOR F or G button to select your center speaker type, then press the ENTER or CURSOR H button to switch to the surround speaker setting.

*Center Small

LargeSmallNone

When “Small” has been selected for the front speakers, “Large” cannot be selected for the center speaker.

3 Press the CURSOR F or G button to select your surround speaker type, then press the ENTER or CURSOR H button to switch to the surround back speaker setting.

*Surr. Small

LargeSmallNone

When “Small” has been selected for the front speakers, “Large” cannot be selected for the surround speakers.

12

ENGLISH