Advanced Operation

Preset memory

•DENON and other makes of components can be operated by setting the preset memory.

•This remote control unit can be used to operate components of other manufacturers without using the learning function by registering the manufacturer of the component as shown in the

list of preset codes ( End of this manual).

•Operation is not possible for some models.

1 Set the MODE 1 switch to “AUDIO” or “VIDEO”.

Set to the AUDIO side for the CD, TAPE or CDR/MD position, and to the VIDEO side for the DVD/VDP, DBS/CABLE, VCR or TV position.

2 Set the MODE 2 switch to the component to be registered.

3 Press the ON/SOURCE and OFF button at the same time.

•The indicator starts flashing.

4 Referring to the included list of preset codes, press the NUMBER buttons to input the preset code (a 3-digit number) for the manufacturer of the component whose signals you want to store in the memory.

5 To store the codes of another component in the memory, repeat steps 1 to 4.

•The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote control unit’s transmitting window while setting the preset memory.

•Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed in the list of preset codes.

•Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and verify correct operation.

•The preset memory can be set for one component only among the following: CDR/MD, DVD/VDP and DBS/CABLE.

2The preset codes are as follows upon shipment from the factory and after resetting:

• TV, VCR .........................................

HITACHI

• CD, TAPE.......................................

DENON

• CDR/MD ........................................

DENON (CDR)

• DVD/VDP .......................................

DENON (DVD)

• DBS/CABLE...................................

ABC (CABLE)

32

ENGLISH

Advanced Operation

Operating a component stored in the preset memory

1 Set the MODE 1 switch to “AUDIO” or “VIDEO”.

Set to the AUDIO side for the CD, TAPE or CDR/MD position, and to the VIDEO side for the DVD/VDP, DBS/CABLE, VCR or TV position.

2 Set the MODE 2 switch to the component you want to operate.

3 Operate the component.

For details, refer to the component’s operating instructions.

Some models cannot be operated with this remote control unit.

ENGLISH