Quick Select Function

With this function, the currently playing input source, input mode, surround mode and volume can be stored in the memory.

1Set the input source, input mode, surround mode and volume to the conditions you want to store.

2Press and hold <QUICK SELECT> until “Memory” appears on the display.[Quick Select Defaults]

 

Input Source

Volume

Quick Select 1

DVD/HDP

–40 dB

Quick Select 2

TV/CBL

–40 dB

Quick Select 3

VCR

–40 dB

To call out the settings, press <QUICK SELECT> at which the desired settings were stored.

Personal Memory Plus Function

This function sets the settings (input mode, surround mode, etc.) last selected for the individual input sources.

When you switch to an input source, the settings are automatically set to the ones that were set the last time that input source was used.

Last Function Memory

This stores the settings as they were directly before the standby mode was set.

When the power is turned back on, the settings are restored to as they were directly before the standby mode was set.

Backup Memory

The various settings are backed up for about 1 week, even if the power is turned off or the power cord is disconnected.

Resetting the Microprocessor

Perform this procedure if the display is abnormal or if operations cannot be performed.

When the microprocessor is reset, all the settings are reset to their default values.

1Turn off the power using <POWER>.2Press <POWER> while simultaneously pressing

<SPEAKER A> and <SPEAKER B>.

3Once the display starts flashing at intervals of about 1 second, release the two buttons.

ENGLISH

Information Zone-Multi Control Remote Playback Setup Connections Started Getting

 

If in step 3 the display does not flash at intervals of about 1 second,

The surround parameters, tone control and the volumes of the different

start over from step 1.

 

speakers are stored for the individual surround modes.

 

Troubleshooting

38