ENGLISH

Getting

Remote Control Unit Operations

Started

 

 

Connections

[Front]

 

 

 

Setup

[MODE

[MODE

 

Playback

SELECTOR 1]

SELECTOR 2]

 

 

Remote

 

 

Control

[Rear]

 

 

 

-Multi

[ZONE2 OFF][MAIN ON]

Zone

[NUMBER]

 

Information

 

 

 

Troubleshooting

 

 

Depending on the model and year of manufacture of your equipment, some buttons may not operate.

Operating DENON AudioComponents1Set [MODE SELECTOR 1] to “AUDIO”.

2Set [MODE SELECTOR 2] to the position for the component to be operated (CD, iPod/NETWORK or TAPE/CD-R/MD).

3Operate the audio component.

b For details, refer to the component’s operating instructions.

b While this remote control unit is compatible with a wide range of infrared controlled components, it may be the case that some component models cannot be operated with this remote control unit.

Presetting

•DENON and other makes of components can be operated by setting the preset memory.

•Operation is not possible for some models.

1Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.

b Set to the AUDIO side for the CD, iPod/NETWORK or TAPE/CD-R/ MD position, and to the VIDEO side for the DVD/VDP, VCR, SAT/ CABLE or TV position.

2Set [MODE SELECTOR 2] to the component to be registered.

3Press [ZONE2 OFF] and [MAIN ON] at the same time. The indicator starts flashing.

4Press [NUMBER] and input the 3-digit number of the brand of the component to be preset. The numbers are shown in the Preset Code Table (vEnd of this manual).

5To store the codes of another component in the memory, repeat steps 1 to 4.

•The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote control unit’s transmitting window while setting the preset memory.

•Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed in the list of preset codes.

•Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and verify correct operation.

•The preset memory can be set for one component only among the following: TAPE/CD-R/MD, DVD/VDP and SAT/CABLE.

Operating Preset Components

1Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.

b Set to the AUDIO side for the CD, iPod/NETWORK or TAPE/CD-R/ MD position, and to the VIDEO side for the DVD/VDP, VCR, SAT/ CABLE or TV position.

2Set [MODE SELECTOR 2] to the component you want to operate.3Operate the component.

b For details, refer to the component’s operating instructions.

b Some models cannot be operated with this remote control unit.

39