Set up speakers

around items indicate the settings.

Here we describe how to set up speakers other than 5.1-channel speakers.

 

For the method of setting up 5.1-channel speakers, see C page 4 “Setup wizard”.

 

First install and connect the speakers to this unit.

Before Auto Setup measurement, the settings shown below can be made.

•Changing the amplifier assignment (Amp Assign)

The signal output from the SURR.BACK/AMP ASSIGN speaker terminal of this unit can be switched to match your speaker environment (vpage 39 “Set up “Amp Assign””).

•Setting the channels to be used (Channel Select)

If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage 40 “Set up “Channel Select””).

version Basic

1

Set up the

 

remote control unit

nn Set up the zone mode

Press ZONE SELECT to switch the zone mode to J(MAIN ZONE).

The J indicator lights.

Press ZONE SELECT

nn Set up the operation mode

Press AMP to set the remote control unit to AMP- operation mode.

Press AMP

2 Connect the setup microphone.

When the setup microphone is connected, the following screen is displayed.

Audyssey Auto Setup

MultEQ XT

Preparation

 

Connect the speakers and place then according to the recommendations in the manual.

Next

[ENTER] Enter

[RETURN] Cancel

3 Select “Next”, and then press

ENTER.

4

Set up “Amp Assign”

Use ui to select “Amp Assign”, and then press

ENTER.

Audyssey Auto Setup

MultEQ XT

Preparation

Set the following items if necessary.

Amp Assign

Channel Select

Auto Setup Start

[ENTER] Enter

[RETURN] Cancel

Amp Assign

 

MultEQ XT

 

 

 

 

Amp Assign

ZONE2

 

 

 

 

 

 

ZONE2

[RETURN] Return

vSee overleaf

version Advanced

Information

39