
Playback in ZONE2 (Separate room)
• You can operate this unit so as to enjoy audio in a room (ZONE2) |
other than the MAIN ZONE (room where the unit is located). |
• You can simultaneously play back the same source in both the MAIN |
Playback
Basic
ZONE, ZONE2. You can also play back separate sources in the MAIN |
ZONE and ZONE2. |
Audio output
Zone playback by speaker output
The ZONE2 audio signals are output from this unit’s SURR.BACK/AMP ASSIGN speaker terminals using the amplifier assignment function.
nnConnecting and setting the speakers
“Amp Assign” setting
(vpage 60) and audio Connecting the speakers signals output
ZONE2
1
2 Press AMP to set the remote control unit to
3 Press ZONE/DEVICE Z to turn on the ZONE2 power.
The indicator on the display lights.
•Also press input source select button when in standby mode, the power turns on.
•When ZONE/DEVICE X is pressed, ZONE2 turns off.
•Power in ZONE2 can be turned on or off by pressing ZONE2 ON/OFF on the main unit.
Inputsource
select
buttons
Adjusting the volume
Use Mdf to adjust the volume.
GAdjustable rangeH – – –
(When the “Volume Display” (vpage 65) setting is “Relative”)
GAdjustable rangeH | 0 – 41 – 99 |
(When the “Volume Display” (vpage 65) setting is “Absolute”)
•At time of purchase, “Volume Limit” (vpage 65) is set to
Turn MASTER VOLUME after pressing ZONE2 SELECT on the main
version
version Advanced
ZONE2 | Output signal : |
|
|
Stereo (L / R) | (L) | (R) | |
|
| ||
|
| w q w | q |
We recommend using high quality
NOTE
It is not possible to play the digital audio signals input from the HDMI, COAXIAL or OPTICAL connectors in ZONE2.
4 Press the input source select button.
The audio signal of the selected source is output to ZONE2.
•To perform an operation with the main unit, press ZONE2 SELECT many times.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select J (MAIN ZONE) in step 1 then press ZONE/DEVICE X.
unit to adjust the sound volume.
Turning off the sound temporarily
Press N.
The sound is reduced to the level set at “Mute Level” (vpage 65) in the menu.
•To cancel, either adjust the volume or press N again.
•The setting is canceled when the zone’s power is turned off.
vSee overleaf
Information
BD | 45 |