System Setup

Setting the Distance

This parameter is for optimizing the timing with which the audio signals are produced from the speakers and subwoofer according to the listening position.

Preparations:

Measure the distances between the listening position and the speakers (L1 to L6 on the diagram at the below).

FL

 

C

 

FR

SW

L3

L1 L2

•The distance changes in units of 1 foot each time the button is pressed. Select the value closest to the measured distance.

•Please note that the difference of distance for every speaker should be 20 ft or less.

Setting the Crossover Frequency

Set the frequency (Hz) below which the bass sound of the various speakers is to be output from the subwoofer.

For speakers that are set to “Small”, frequencies under the crossover frequency are cut before the signal is output, and the low frequency component that was cut is output from the subwoofer or the speakers that are set to “Large”.

ENGLISH

System Setup

Setting the Test Tone

Set the volume of the various speakers so that the sound output from the speakers and the subwoofer seems to have the same volume level.

1 Press F to select “Yes”.

2 Press F G to set, then press H.

Auto:

Adjust the level while listening to the test tones produced automatically from each speaker.

Test tones are automatically emitted from each speaker.

L4

Listening position

1 Press F G to set.

Manual:

Adjust with the speaker from which the test tone is output switched manually.

L5 L6

SL

SR

1 Press F G to set.

2 Press ENTER or H to enter the setting and switch to the Crossover Frequency setting.

1

6

F L

1 5 f t

 

 

 

 

 

 

 

 

 

1 1

S W

1 2 f t

 

 

 

 

 

2

 

 

 

 

 

 

1 2 C r . O v e r 8 0 H z

40, 60, 80, 90, 100, 110, 120, 150, 200, 250 Hz:

Set as desired according to your speakers’ bass playback ability.

2 Press ENTER or H to enter the setting and switch to the Test Tone setting.

1

1 2 C r . O v e r 1 0 0 H z

2

1 3 T . T o n e Y e s <

•The crossover frequency mode is valid only when subwoofer is set to “ON”, and when one or more speakers are set to “Small”, as

described in section “Setting the Speaker Configuration” ( page 17).

•Set to “80 Hz” when using regular speakers. When using small speakers, we recommend setting to a higher frequency.

18

3 When “Auto” mode is selected: Press F G to adjust the volume.

-1• Test tones are output automatically, in the order shown below.

FL C FR

SW SL SR

The volume can be adjusted within the range –12 dB to +12 dB.

3 When “Manual” mode is selected:

Press D H to select the speaker, then press F G to -2adjust the volume.

4 Press ENTER to finish the Test Tone setting.

5 Press ENTER to enter the setting and switch to the Option Setup.

ENGLISH