System Setup

Setting the EXT. IN Subwoofer Level

Sets the playback level of the analog signal that was input to the EXT. IN subwoofer terminal.

1 Press F G to set.

+15 dB, +10 dB, +5 dB, 0 dB:

Sets the playback level of the analog signal that was input to the EXT. IN subwoofer terminal.

2 Press ENTER or H to enter the setting and switch to the Auto Preset Memory setting.

1

6E X T . I n S W + 1 0

2

7 P r e s e t < S t a r t

Setting the Auto Preset Memory

Up to 56 FM stations can be preset automatically ( page 30).

1 Press F to start.

• “CH” blinks on the display and searching begins.

• “Completed” appears once searching is completed.

2 Press ENTER to enter the setting and switch to the Option Setup.

1

S e a r c h

C O M P L E T E D

Option Setup

Setting the Volume Control

This sets the volume level of output.

1 Press F G to select “3. Op”, then press ENTER.

2 Press D H to select the item, then press F G to set.

Volume Limit:

Set the volume’s upper limit.

•0 dB, –10 dB, –20 dB:

The volume cannot be increased above the selected levels.

•OFF:

If you do not want to set a volume limit, select “OFF”.

In this case, the volume can be set to the AVR-487’s maximum volume (output) level of +18 dB, which is extremely loud.

Power On Volume Level:

•LAST:

The volume set when the AVR-487 was last used is stored in the memory and set when the power is turned on.

•– – – (Mute):

The volume is always muted when the power is turned on.

•–80 dB ~ +18 dB:

Set the volume level when the power is turned on.

You can adjust the volume level within the range of –80 to +18 dB.

Muting Level:

Set the level of volume attenuation in the mute mode.

•FULL:

The volume is fully muted.

•–40 dB, –20 dB:

The volume is lowered 40 dB or 20 dB from the current level.

3 Press ENTER or H to enter the setting and switch to the Auto Surround Mode setting.

ENGLISH

System Setup

1

O p t i o n S e t u p

2

1L i m i t - 1 0 d B

2 P . O n L A S T

3M u t e F U L L

3

4AutoSurr. ON

Setting the Auto Surround Mode

Set whether or not to store the surround mode last played for the input signal.

The surround mode used at last for the three types of input signals shown below is stored in the memory, and the signal is automatically played with that surround mode the next time it is

input.

qAnalog and PCM 2-channel signals (STEREO)

w2-channel signals of Dolby Digital, DTS or other multi-channel format (DOLBY PLIIx Cinema)

eMulti-channel signals of Dolby Digital, DTS or other multi- channel format (DOLBY/DTS SURROUND)

Default settings are indicated in ( ).

1 Press F G to set.

2 Press ENTER to enter the setting and switch to the Speaker Setup.

2

•If an FM station cannot be preset automatically due to poor

reception, use the “Manual tuning” operation ( page 31) to tune in the station, then preset it using the manual “Preset memory”

operation ( page 31).

20

1

4 A u t o S u r r . O F F

2

ENGLISH