Denon DN-S3500 THE SLIPMAT / CONNECTIONS

ENGLISH

2INSTALLING THE PLATTER, THE SCRATCH DISC AND

THE SLIPMAT / CONNECTIONS

(2) CONNECTIONS

1. Turn off the POWER switch.

2. Connect the RCA pin cords between the DN-S3500 outputs and inputs of your mixer.

3. If your mixer has Fader Start function such as our DENON Mixer, connect FADER jack to the mixer using 3.5

mm stereo mini cord.

POWER ON OFF

DIGITAL OUT

LINE OUTFADER IN OUT

MEMO

LINE1 FADER

PGM 1 FADER

LINE

OUT

(3) INSTALLATION

Please set up DN-S3500 horizontally.

(4) INSTALLING THE 7” (17cm) RECORD ADAPTOR

Your own 7” (17cm) vinyl record can be installed on this product by using the provided adaptor.

This original design grants you the freedom to use your favorite vinyl record for that ultimate analog turntable

feel.

*Make sure the record used is flat and not warped.

•7” (17cm) record adaptor accessories

qAdaptor (2)........................................................1

wScrew (<head)................................................3

eFixing Plate.......................................................1

DN-X300

(1) INSTALLING THE PLATTER, THE SCRATCH DISC and THE SLIPMAT

•Accessories 1. Install the Platter on the taper boss of the motor.

2. Install the Slip Mat on the Platter.

3. Insert D hole of the Scratch Disc on the D shaft of

the Motor.

NOTE: The printed face is located on the Slip Mat

side.

4. Insert the Adaptor according to the direction of the

arrow.

NOTE: Please note the direction of insertion.

NOTE:

Depending on the RECORD you choose, friction

with the Slipmat may not be enough, which can

cause an undesired drag sound.

If so, use a different record that’s thicker or

heavier.

1. Set Adaptor (2) in the hole of 7” record.

2. Fix Plate with 3 screws. (<head).

3. Insert D hole of the Adaptor (2) on the D shaft of the

Motor.

4. Insert the Adaptor (1) on the Adaptor (2).

qAluminum Platter..............................................1

wScratch Disc......................................................1

eSlip Mat............................................................1

rAdaptor (1)........................................................2

(One is for spare parts.)

Scratch Disc

(Groove side

DOWN)

D shaft

Slip Mat

Platter

Taper Boss

(Motor Unit)

Fig. 1 Scratch Disc

Adaptor (1)

Fig. 2

Fig. 3

Screw (<head)

Fixing Plate

7” (17 cm) record

Adaptor (2)

Fig. 1

Fig. 2 7” (17cm) Disc

Adaptor (2)

Adaptor (1)

Slip Mat

Adaptor (1)

CAUTIONS:

•Do not touch the motor unit.

•Do not turn on the power without Platter.

NOTE:

Please note the fall of Platter when you move DN-

S3500 after Platter is set.