
GExample:2H Setup Menu Screen
Click to determine a
setting
After entering characters, click “Set” to set, or click “Def” to return to initial setting
Click the menu from which you want to make settings
The display on the right becomes each setting screen
Click “SAVE” when you want to save settings, and click “LOAD” when you want to call settings
Becomes each operation screen
Enter figures or click < > to make the setting, and then click “Set”.
GExample:3H PDA menu screen
Select when performing main control
NOTE
You cannot change setup menu operations on the PDA menu screen.
Other Operations and Functions
Personal Memory Plus Function
This function sets the settings (input mode, etc.) last selected for the individual input sources.
When you switch to an input source, the settings are automatically set to the ones that were set the last time that input source was used.
Last Function Memory
This stores the settings as they were directly before the standby mode was set.
When the power is turned back on, the settings are restored to as they were directly before the standby mode was set.
Backup Memory
The various settings are backed up for about 1 week, even if the power is turned off or the power cord is disconnected.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if operations cannot be performed.
When the microprocessor is reset, all the settings are reset to their default values.
1Turn off the power using the <ON/STANDBY> button.
2While pressing the <SETUP> and <RETURN> buttons, press the <ON/STANDBY> button for at least one second.
3Once the display starts flashing at intervals of about 1 second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
Resetting the remote control unit
Resetting in case of wrong operation of the remote control, or when operation is impossible.
1Hold down the [ALL OFF] button on the remote control unit and press the [ADVANCED SETUP] button with
the tip of a pen.
The Transmission Indicator light blinks four times.
2Hold down the [ALL ON] button on the remote control unit and press the [ADVANCED SETUP] button with
the tip of a pen.
The Transmission Indicator (DVP) light blinks four times.
Specifications Troubleshooting Information Playback Setup Connections Started Getting
NOTE
•To perform web control, you must connect a web control device such as a PC to the same network as the
•With web control, some network settings, etc., cannot be set.
•When updating firmware, settings made by the web controller may
be reset. | 26 |
|