Denon PMD340, PMD331 Using a Remote Control Not Included, Using Synchro Recording, English

Synchro Recording

ENGLISH

Using Synchro Recording

This CD player has a CD SYNC function that makes it easy to record for this CD player to be used in combination with a cas- sette recorder.

-The CD SYNC function works in combination with a cassette deck that is equipped with the synchro recording function.

-Connect the remote control jack (RC5) output b on this CD player to the (RC5) input on the cassette deck, and then prepare the cassette deck for synchro recording.

Refer to figure 2 for the connection method.

Procedure

1.Put the cassette recorder into the synchro recording mode.

2.With the CD player in the stopped state, press the button !7to start playing the CD.

The cassette recorder automatically begins recording.

3.When the CD player finishes playing, it stops and the cassette recorder enters the paused state.

4.To continue recording, repeat this procedure, starting from step 2.

Tips:

-When performing synchro recording with a non-cassette recorder, such as a CD-R or CD-RW recorder, the operation may differ, so check the instruction manual provided with your recorder.

-When performing synchro recording, set preset menu No.17 “CD sync” to “On” .

-Make sure to set preset menu item No.1 “Auto Cue” to “Off” and No.13 ”Start” to “Play” or “Stop” before utilizing CD Sync function.

( See also page 17.)

Using a Remote Control (Not Included)

-This CD player can receive signals directly from an infrared remote control transmitter within about 5 meters (15 feet.) Note that the CD player might not operate correctly if the remote control transmitter is not pointed in the direction of the sensor on the CD player, or if there is an obstacle between the transmitter and the sensor.

Area where an infrared remote control transmitter can be used

Approximately 5 meters 約5m

(15 feet)

CD player (This unit)

60°�

60°

The figure depicts the PMD331/PMD340.

Infrared remote control transmitter

RC5 Code chart

-This CD player can be controlled through its infrared sensor

@9on the front panel when it receives remote control signals that supports RC5 signals as shown in the table at right. These remote control codes can also be used if sent through the RC5 remote control jack b found on the rear panel of the CD player.

Tip:

Because the infrared remote sensor @9on the front panel of the CD player and the RC5 remote control input jack on the rear panel of the CD player both support the RC5 codes listed in the table at right, this CD player can be controlled through the infrared remote control sensor of any device that supports RC5 codes.

*Remote control codes that are marked with an asterisk are not supported by the PMD330.

INPUT

Command	Cord
Play	2053
Pause	2048
Cue	2059-10
Stop	2054

FF2052

FR(REW) 2050

Index +	2034
Index -	2035
Next	2032
Previous	2033
Pitch +	2038
Pitch -	2039
Pitch Bend +	2038-10*
Pitch Bend -	2039-10*
A - B	2059
Program	2041
Pitch On/Off	2037
Open/Close	2045
Time	2011

INPUT

OUTPUT

Command	Cord
Mode	2036-10
Preset	2041-12
END monitor	2043-10
CD-TEXT	2088

02000

12001

22002

32003

42004

52005

62006

72007

82008

92009

CD Sync start	1856
CD Sync stop	1857

15