Denon S-102 Setting the preset memory function, Setting the punch through function, Remote Control Unit Operations, Number, 2Operate the component

	ENGLISH
Getting	Remote Control Unit Operations
Started
	[TV INPUT]
Connections
	Signal transmission
	indicator	[AUDIO/RDS]
Setup		[ZOOM/RT]
		[NUMBER]
Playback
		[REPEAT]
Control Remote		[CALL]
Information	[SOURCE
	CONTROL]
Troubleshooting

About the button names in these explanations

<> : Buttons on the main unit

[ ] : Buttons on the remote control unit

Button name only:

Buttons on the main unit and remote control unit

Setting the preset memory function

DENON and other makes of components can be operated by setting the preset memory.

This remote control unit can be used to operate components of other manufacturers without using the learning function by registering the manufacturer of the component as shown in the list of preset codes (vEnd of this manual).

1Set [SOURCE CONTROL] to the component to be registered.

2Press [AUDIO/RDS] and [ZOOM/RT] at the same time.

The indicator starts flashing.

3Referring to the included list of preset codes (vEnd of this manual), press [NUMBER] (0 ~ 9) to input the preset code (a 3-digit number) for the manufacturer of the component whose signals you want to store in the memory.

4To store the codes of another component in the memory, repeat steps 2 to 3.

•The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote control unit’s transmitting window while setting the preset memory.

•Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed in the list of preset codes.

•Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and verify correct operation.

•Operation is not possible for some models.

Operating a component stored in the preset memory

1Set [SOURCE CONTROL] to the component you want to operate.

2Operate the component.

b For details, refer to the component’s operating instructions.

b Some models cannot be operated with this remote control unit.

Setting the punch through function

“Punch Through” is a function allowing you to operate [SOURCE CONTROL] and [TV INPUT] on “TV”, “SAT/CABLE” or “VCR” components when in the “DVD / CD / FM/AM / iPod” mode. By default, nothing is set.

1Set [SOURCE CONTROL] to the component to be registered (DVD / CD / FM/AM / iPod).

2Press [CALL] and [REPEAT] at the same time. The indicator starts flashing.

3Input the number of the component you want to set.

Number

TV1

SAT/CABLE	2
VCR	3
No setting	0

32