Cautions on Installation

Note:

For proper heat dispersal, do not install this unit in a confined space, such as a bookcase or similar enclosure.

(ADV-S102)

b Note

b

 

b

b

Wall

CAUTION

Be sure to fasten the speaker cords to a wall, etc., to prevent people from tripping over them or otherwise pulling on them accidentally, causing the speaker systems to fall.

Be sure to check for safety after installing the speaker systems. Afterwards, perform safety inspections at regular intervals to be sure there is no danger that the speaker systems will fall. DENON will accept no responsibility for damages or accidents caused by inappropriate choice of the place of installation or improper installation procedures.

ENGLISH

Setup Connections Started Getting

(DSW-S102)

b Note

b

b

b

Wall

D The quality of the sound produced from the speaker is affected by the size and type of the room, as well as by the method of installation. Consider the points listed below before installing the speaker.

Placing speakers on the same stand or shelf as the record player could result in howling.

If there is a wall, glass door, etc., behind or to the sides of the speakers, resonance and reflections can be prevented by using a thick curtain, etc.

The speakers are of the shielded type. With some TVs, however, placing the speakers near the TV could cause color blotching on the TV's picture. If this happens, turn the TV’s power off, move it away, wait 15 to 30 minutes, then turn theTV’s power back on. If the color blotching persists, move the speakers further away.

Mount on a wall sufficiently sturdy to bear the weight of the speaker. Note that DENON will except no responsibility whatsoever for damages or accidents caused by the speaker falling.

To ensure safety, have a specialist install the speakers on the wall.

Be sure to fasten the speaker connection cables to the wall, etc., so that you do not get your feet or hands caught in them, causing the set to fall.

Place the subwoofer on a flat floor to prevent accidents due to the subwoofer tipping over.

Do not place a record player, CD player or other such device on top of the subwoofer.

Do not set the subwoofer with the baffle surface against the floor. Doing so will prevent you from achieving satisfactory sound effects.

Other Cautions

Switching the input function when input terminals are not connected.

A clicking noise may be produced if the input function is switched when nothing is connected to the input terminals. If this happens, either turn down the VOLUME control knob or connect components to the input terminals.

When watching TV broadcasts with the S-102’s power turned on, depending on the conditions of the TV broadcast's signals, striped patterns may appear on the picture. This is not a malfunction of the S-102 or the TV. Turn the S-102’s power off when watching TV.

Note that if a magnet or a piece of furniture or equipment using magnets is placed nearby, interaction with the S-102 could result in color blotching on the TV.

NOTE

This product uses a semiconductor laser. To ensure stable operation, it is recommended to use the product indoors at a temperature of 5 °C (41 °F) ~ 35 °C (95 °F).

Troubleshooting Information Control Remote Playback