OWNER’S MANUAL
INSTALLATION
Continued
INSTALLING LOGS (CGD3924NR)
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. If so, repo-
Back Log (#1)
Peg
Hole in
Grate Base
Burner
Front Log (#3)
Recess
Post
Post
Figure 19 - Installing Front Log (#3)
sition logs according to the log installation instructions in this manual. Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1. Locate pegs on the bottom of back log |
(#1). Slide these pegs into the holes in |
the grate base behind the burner (see |
Figure 17 - Installing Back Log (#1)
Middle Log (#2)
Tab
Burner
Cutout
Notches
Crossover Log (#1)
Figure 17). |
2. Place the base of the middle log (#2) in |
the |
front of the back log. The cutout on the |
right of the middle log should fit over the |
burner (see Figure 18). Make sure the |
front of the middle log is resting on the |
tabs of the grate base and the cutout area |
is centered over the burner “U” bend. |
3. Locate the recesses on the back of the |
front log (#3). Fit these recesses be- |
tween the posts of the grate base (see |
Figure 19). |
4. Locate the notches in the bottom of the |
crossover log (#4). Place the crossover |
log on top of the middle log and front |
log. Make sure the notches of the cross- |
over log lines up with rectangular knobs |
on top of the middle and front logs (see |
Figure 20). |
5. Add lava rock around base of heater. |
Do not place any lava rock on logs or |
burner. |
“U” Bend
Slot
Figure 18 - Installing Middle Log (#2)
Rectangular
Knobs
Figure 20 - Installing Crossover Log (#4)
Continued
104306 | 13 |
