CGD3924NR, CGB3924NR and CGB3930NR

UVENTED NATURAL GAS LOG HEATER

INSTALLATION

Continued

INSTALLING HEATER BASE ASSEMBLY

CAUTION: Do not remove the metal data plates attached to the heater base assembly. The data plates contain important warranty information.

WARNING: You must secure this heater to fireplace floor. If not, heater will move when you adjust controls. Moving heater may cause a gas leak.

WARNING: If installing in a sunken fireplace, special care is needed. You must raise the fire- place floor to allow access to heater control panel. This will in- sure adequate air flow and guard against sooting. Raise fireplace

Installation Items Needed

hardware package (provided with heater)

approved flexible gas hose (not provided) (if allowed by local codes)

sealant resistant to propane/LP gas, not provided

electric drill with 3/16" masonry drill bit

two (2) 9-volt alkaline batteries (not in- cluded)

1.Apply pipe joint sealant lightly to male threads of the fitting to be threaded into gas regulator. Connect approved flex- ible gas hose to gas regulator of heater (see Figure 10).

Flexible Gas Hose (if allowed by local codes)

Fitting

2.Locate masonary screws in hardware package.

3.Position heater base assembly in fire- place.

4.Mark screw locations through holes in mounting flanges (see Figure 11). If in- stalling in a brick-bottom fireplace, mark screw locations in mortar joint of bricks.

5.Remove heater base from fireplace.

6.Drill holes at marked locations using 3/16" masonry drill bit.

7.Attach base assembly to fireplace floor using two masonry screws (in hardware package) (see Figure 11).

8.Connect to gas supply. See Connect- ing To Gas Supply, page 11.

Masonry Screw

floor with non-combustible mate- rial. Make sure material is secure.

CAUTION: Do not pick up heater base assembly by the burner. This could damage heater. Only handle base assem- bly by grates.

IMPORTANT: Make sure the heater burn- ers are level. If heater is not level, heater will not work properly.

Figure 10 - Attaching Flexible Gas Hose to Heater

Mounting

Flanges

Figure 11 - Attaching Base Assembly to

Fireplace Floor

10

104306

Page 10
Image 10
Desa CGB3930NR, CGB3924NR installation manual Installing Heater Base Assembly, Installation Items Needed