OWNER’S MANUAL
SAFETY
INFORMATION
Continued
14.Turn heater off and let cool before ser- vicing. Only a qualified service person should service and repair heater.
15.Operating heater above elevations of 4,500 feet could cause pilot outage.
PRODUCT IDENTIFICATION
Crossover Log | Back Log |
Front Log
| Burner |
Piezo | Middle Log |
Ignitor |
|
Control Knob | Base Grate |
Figure 1 -
Back Log
Crossover Log
Front Log
Burner
Piezo
Ignitor
Control Knob
Figure 2 -
LOCAL CODES
Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code, ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Note: Where listed vented decorative logs are required, thermostat models are not permitted.
UNPACKING
CAUTION: Do not remove the metal data plates from the grate assembly. The data plates contain important product information.
1.Remove logs and heater base assem- bly from carton. Note: Do not pick up heater base assembly by burners. This could damage heater. Always handle base assembly by grate.
2.Remove all protective packaging ap- plied to logs and heater for shipment.
3.Check all items for any shipping dam- age. If damaged, promptly inform dealer where you bought heater.
PRODUCT
FEATURES
OPERATION
This heater is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by realistic, dancing yellow flames. This heater is designed for
107123 | 3 | For more information, visit www.desatech.com |
