Desa CGD3924NT, CGD3930NT, CGD3018NT, CGB3924NT, CGB3930NT, CCL3018NT, CCL3924NT, CCL3930NT

VENT-FREE NATURAL GAS LOG HEATER

INSTALLATION

Continued

Dual Burner Biltmore Split Oak Models

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION:Afterinstallationand periodically thereafter, check to en- sure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, reposition logs ac- cording to the log installation in- structions in this manual. Flames contacting logs will create soot.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place the front log (#1) on the grate fin- gers. Make sure the front log rests firmly between the grate fingers and the grate base (see Figure 27).

2.Place the base of the middle log (#2) in the U-shaped slots of the grate base. The cutout on the right of the middle log should fit over the burner (see Figure 28). Make sure the front of the middle log is resting on the tabs of the grate base.

3.Locate pegs on the bottom of back log (#3). Slide these pegs into the holes in the grate base behind the burner (see Figure 29).

Front Log (#1)

Grate

Fingers

Grate Base

Figure 27 - Installing Front Log (#1) (CCL3930NTA Shown)

4.Locate holes on the bottom of crossover log (#4). Slide front hole onto the left peg (CCL3924NT or CCL3930NTA) or middle peg (CCL3018NT) on the middle log (#2) and the peg on the back log (#3). See Figure 30 for placement.

Middle Log (#2)

Burner

Tab	U-Shaped
	Slot

Figure 28 - Installing Middle Log (#2) (CCL3930NTA Shown)

Pegs

Hole in

Grate Base

Burner

Figure 29 - Installing Rear Log (#3) (CCL3930NTA Shown)

Log #4

Pegs

Log #2 Log #3

Figure 30 - Installing Crossover Log (#4) (CCL3930NTA Shown)

5.For CCL3924NT and CCL3930NTA Only: Locate peg and hole on the bot- tom of crossover log (#5). Slide the peg into the hole located in crossover log (#4). Slide the hole onto the peg on front log (#1). See Figure 31.

For CCL3018NT Only: Locate holes on the bottom of crossover log (#5). Slide the holes over the left pegs on middle log (#2) and front log (#1). See Figure

Crossover Log (#4)

Front Log (#1)

Figure 31 - Installing Crossover Log (#5) (CCL3930NTA Shown)

Crossover

Log (#4)

Front

Log (#1)

Figure 32 - Installing Crossover Log (#5) (CCL3018NT Only)

For more information, visit www.desatech.com 16 107123