OWNER’S MANUAL
FIREPLACE INSTALLATION
Continued
8.Plug in blower power cord.
a.If your fireplace system is installed as a freestanding unit with an ac- cessory mantel, determine whether the power cord will exit the left side or the right side of the firebox. In- stall one plastic bushing provided into the 1 1/2" hole in the outer cas- ing through which the power cord will exit. Install the second plastic bushing provided into the floor sup- port bracket if exiting through the right side (see Figure 33). Route power cord through (both) plastic bushing(s) and plug the power cord into a properly grounded
b.If your fireplace system installation is recessed and/or
Lower Rear
Wall of
Firebox
Wrapper
9.Check to make sure that the power cord is completely clear of the blower wheel and that there are no other foreign ob- jects in blower wheel. Turn blower on and check for operation. Turn blower off by rotating knob fully counterclock- wise before continuing.
WARNING: Never touch the blower wheel while in operation.
Thermal Switch
Figure 31 - Locating Thermal Switch Against Back of Firebox
Speed
Control
Control
Knob
Control Shaft
Locknut
10.Peel off the backing paper and stick the supplied wiring diagram decal on the firebox bottom approximately 3" to the right of the blower speed control bracket (Figure 33).
WARNING: Failure to position the parts in accordance with sup- plied diagrams or failure to use only parts specifically approved with this heater may result in dam- age or personal injury.
11.Connect or reconnect gas supply to fire- place per Connecting Fireplace to Gas Supply on page 19 of this manual.
NOTICE: A qualified service per- son must connect fireplace to gas supply. Follow all local codes.
Lower Louver
Blower Panel
Screws
Exhaust Port
Top
Mounting
Tab
Figure 30 - Mounting Blower to Firebox
Figure 32 - Attaching Speed Control to Firebox
Wiring | Plastic | |
Diagram | ||
Bushing | ||
|
Blower Speed
Control Bracket
Figure 33 - Installing Plastic Bushing and Wiring Diagram Sticker
Continued
105456 | 17 |
