Desa CHDV34(N/P)(A) Removing/Replacing Glass Door, Installing Remote Receiver, Owner’S Manual

OWNER’S MANUAL

FIREPLACE INSTALLATION

Continued

INSTALLING OPTIONAL WIRELESS HAND-HELD REMOTE CONTROL - CGHRC SERIES/CGHRCT SERIES

Installing Remote Receiver

1.Open bottom louver and locate the switch bracket on the left.

2.Unscrew the switch bracket. Lean bracket forward so you are able to ac- cess the back of the remote receiver.

3.Locate the battery clip mounted on the back of the receiver. Slide a 9-volt bat- tery (not included) through the clip.

4.Attach the terminal wires to the battery.

5.Remove wire from TH to TPTH on control valve (see Figure 40).

6.Connect wires from receiver to TH and TPTH to control valve (see Figure 41).

5.Replace the switch bracket.

Figure 40 - Disconnecting TH to TPTH Wire

To

Optional

Remote

Accessory

Figure 41 - Control Valve Terminals

Receiver

Terminal

Wires

Battery Clip

9-Volt Battery

Figure 42 - Attaching Battery to Receiver

Installing 9-Volt Battery in Hand- Held Remote Control Unit

1.Remove battery cover on back of re- mote control unit.

2.Attach terminal wires to a 9-volt bat- tery (not included). Place battery into the battery housing.

3.Replace battery cover onto remote con- trol unit.

	Battery
Terminal	Cover	Remote
Wires		Control Unit
9-Volt
Battery
		Battery
		Housing

Figure 43 - Installing Battery in Hand- Held Remote Control Unit

REMOVING/REPLACING GLASS DOOR

You must remove glass door to install op- tional brick liners, logs, lava rock, and em- ber material.

CAUTION: Do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For re- placement part information see Replacement Parts, page 31.

1.Remove the upper louver panel by lift- ing upward and out (see Figure 44).

2.Remove the screws from the three tabs at the top of the glass door while hold- ing door securely keeping it from fall- ing forward.

3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 45).

4.To replace glass door, follow the above instructions in reverse.

Attaching Magnetic Decorative

Brass Strips

(Optional Installation)

Before attaching strips to fireplace, remove plastic film from brass pieces. After install- ing door, attach these strips to the top and bottom of glass door frame.

Top Louver

Panel

Figure 44 - Removing Top Louver Panel

Screw

Glass

Door

Assembly

Lower Bracket for

Glass Door Assembly

Figure 45 -Removing/ReplacingGlassDoor

Continued

105456 21