14
INSTALLATION
Installing Logs, Models CGS2718P, CGS2718N, CGS3124P, CGS3124N, SGS3124P and SGS3124N (Cont.)
Installing Logs, Models CLD3018PA, CLD3018NA, CLD3018PT, CLD3018NT, CLD3924PTA and CLD3924NTA
INSTALLATION
Continued
2.Locate the notches on the back of the front log (#2). Slide these notches over the tabs of the grate base (see Figure 19).
3.Locate the notches in the bottom of the crossover log (#3). Place the crossover log on top of the back log and front log. Make sure the notches of the crossover log line up with rectangular knobs on top of the back and front logs (see Figure 20).
4.Add lava rock around base of heater if desired. Do not place lava rock on logs or burner.
Front Log (#2)
Notch
Tabs of
Grate Base
Figure 19 - Installing Front Log
INSTALLING LOGS, MODELS CLD3018PA, CLD3018NA, CLD3018PT, CLD3018NT, CLD3924PTA AND CLD3924NTA
WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, reposition logs ac- cording to the log installation instructions in this manual. Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place the base of the middle log (#1) in the
Crossover Log (#3)
Notch
Notch
Rectangular Knob
2.Locate pegs on the bottom of back log (#2). Slide these pegs into the holes in the grate base behind the burner (see Figure 22, page 15).
Middle Log (#1)
Tab
Burner
“U” Bend
Rectangular Knob
Figure 20 - Installing Crossover Log
U-Shaped Slot
Figure 21 - Installing Middle Log (#1)
For..com